iglidur® J | The versatile endurance runner - Over 250 dimensions available from stock
- Low wear many different shaft materials
- Low coefficients of friction in dry operation
- Vibration dampening
- Good chemical resistance
- Best material to use with low-cost soft shaft materials
- Low moisture absorption
One main advantage of iglidur® J thrust washers is the combination of a low coefficient of friction when running dry and the low stick-slip tendency. With a recommended maximum surface pressure of 35 MPa, iglidur® J thrust washers are not suitable for extreme loads.
Typical application areas
Vending machineryPrinting industryBeverage industryAviationCleanroom You can find further applications here:
Industry solutions When to use it?- For high speeds
- For highest wear resistance at low to medium pressures
- Low wear against different shafts
- When a low coefficient of friction in dry operation is required
- Vibration dampening
- When good chemical resistance is required
- Best performance with low-cost soft shaft materials
- Low moisture absorption
| When not to use it?- When high pressure loads occur
iglidur® G, thrust washer, mm iglidur® W300, thrust washer, mm - If temperatures are higher than +90°C
iglidur® G, thrust washer, mm iglidur® Z, thrust washer, mm - When a cost-effective bearing for occasional movements is necessary
iglidur® G, thrust washer, mm
|
Use our filter options to find the suitable product
Certificates and standards